BS EN 62031 LED modules for general lighting — Safety specifications

BS EN 62031-2008/ IEC 62031:2008  LED modules for general lighting - Safety specifications
一般照明用发光二极管(LED)模块.安全规范,此国际标准规定了发光二极管的一般要求和安全要求

EN 62031普通照明用发光二极管(LED)模块安全规范
其适用之范围为各类作为光源使用之 LED模组，不论此LED模组包含或不包含电源供应线路均可适用。当LED模组包含电源供应线路时，其适用输入电压为交流电1000伏特以下，频率 50Hz或 60Hz，或直流电 250 伏特以下。

Scope
This International Standard specifies general and safety requirements for light-emitting diode
(LED) modules:
٭   LED modules without integral control gear for operation under constant voltage, constant
current or constant power;
٭   self-ballasted LED modules for use on d.c. supplies up to 250 V or a.c. supplies up to  1 000 V at 50 Hz or 60 Hz.
NOTE 1  The safety requirements for separate control gear are specified in IEC 61347-2-13. The performance requirements for separate control gear are specified in IEC 62384.

NOTE 2  Requirements for LED modules with integrated control gear and equipped with a lamp cap (self-ballasted lamp), intended for mains voltage   general lighting service retrofit applications (thereby replacing existing lamps with identical lamp caps) are specified in IEC 60968 (an amendment to the present edition or a new edition with extended scope is in preparation).
Requirements for LED modules with integrated control gear and equipped with a lamp cap (self-ballasted lamp), intended for non-mains voltage general lighting service retrofit applications (thereby replacing existing lamps with identical lamp caps) are under consideration.

NOTE 3   Where in the requirements of  this standard both types of LED modules, with and without integral control
gear, are addressed, the word “modules” is used instead. Where only the expression “LED module(s)” is used, it is
understood to refer to the type without integral control gear.