FCC logo与铭牌 - FCC SDOC - 警告语
§15.19 Labeling requirements.(a) In addition to the requirements in part 2 of this chapter, a device subject to certification, or Supplier's Declaration of Conformity shall be labeled as follows:(1) Receivers associated with the operation of a licensed radio service, e.g., FM broadcast under part 73 of this chapter, land mobile operation under part 90 of this chapter, etc., shall bear the following statement in a conspicuous location on the device:This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference.(2) A stand-alone cable input selector switch, shall bear the following statement in a conspicuous location on the device:
This device complies with part 15 of the FCC Rules for use with cable television service.
(3) All other devices shall bear the following statement in a conspicuous location on the device:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
(4) Where a device is constructed in two or more sections connected by wires and marketed together, the statement specified under paragraph (a) of this section is required to be affixed only to the main control unit.
(5) When the device is so small or for such use that it is impracticable to label it with the statement specified under paragraph (a) of this section in a font that is four-point or larger, and the device does not have a display that can show electronic labeling, then the information required by this paragraph shall be placed in the user manual and must also either be placed on the device packaging or on a removable label attached to the device.
(b)-(c)
(d) Consumer electronics TV receiving devices, including TV receivers, videocassette recorders, and similar devices, that incorporate features intended to be used with cable television service, but do not fully comply with the technical standards for cable ready equipment set forth in §15.118, shall not be marketed with terminology that describes the device as “cable ready” or “cable compatible,” or that otherwise conveys the impression that the device is fully compatible with cable service. Factual statements about the various features of a device that are intended for use with cable service or the quality of such features are acceptable so long as such statements do not imply that the device is fully compatible with cable service. Statements relating to product features are generally acceptable where they are limited to one or more specific features of a device, rather than the device as a whole. This requirement applies to consumer TV receivers, videocassette recorders and similar devices manufactured or imported for sale in this country on or after October 31, 1994.
15.19 标签要求。（a） 除本章第2部分的要求外，须对受认证的设备或供应商的合格声明注明如下：（1） 与有执照的无线电服务操作有关的接收方，例如本章第73部分下的调频广播、本章第90部分下的土地移动操作等，应在设备上的显眼位置承担下列声明：此设备符合 FCC 规则的第 15 部分。操作必须遵守此设备不造成有害干扰的条件。
（2）独立电缆输入选择器开关，在设备显著位置应承担下列说明：此设备符合 FCC 规则第 15 部分，用于有线电视服务。
（3）所有其他设备在设备显著位置应注明下列声明：此设备符合 FCC 规则的第 15 部分。操作受以下两个条件的约束：（1） 此设备不得造成有害干扰，（2） 此设备必须接受收到的任何干扰，包括可能导致不良操作的干扰。
（4） 如果设备由电线连接并一起销售的两个或多个部分构建，则本节第（a）款所述声明仅应贴在主控制单元上。
（5） 当设备体型小或用于此类用途，以四点或四点以上字体将本节（a）款所述声明标记为不切实际，并且设备没有显示电子标签的显示屏时，应将其放置在用户手册中，并且必须将其放置在设备包装上或在设备上连接到设备上的可拆卸标签。
（b） -（c） [保留]
（d） 消费类电子电视接收设备，包括电视接收器、录像机和类似设备，如果包含打算用于有线电视服务的功能，但未完全符合 15.118 中规定的电缆就绪设备的技术标准，则不得销售将设备描述为"电缆就绪"或"电缆兼容"的术语，"或者，否则会传达设备与电缆服务完全兼容的印象。有关用于电缆服务的设备的各种功能或此类功能的质量的事实陈述是可以接受的，只要此类陈述并不意味着设备与电缆服务完全兼容。与产品功能相关的语句通常可以接受，因为它们仅限于设备的一个或多个特定功能，而不是整个设备。这项要求适用于1994年10月31日或之后在我国制造或进口的消费电视接收机、录像机和类似设备。
美国 FCC 警告语
加拿大ic警告语
页:
[1]
